Thermotouch 9.2mG Glass Manual Thermostat

  • Manual control

    Thermotouch 9.2mG features a simple to use manual function that allows you to manually control the temperature of your underfloor heating.

  • Sensor mode

    Thermotouch 9.2mG is supplied with a floor sensor probe and an option for using an ambient sensor to ensure total control over your heating system.

  • Back box supplied

    Supplied back box for use with plaster walls for ease of installation.

  • Use with home automation

    Thermotouch 9.2mG has the function to be set to “On as Before”, allowing you to set your comfort level and use it with off-peak electricity or Home Automation systems.

Manual Thermostat Options

Thermotouch 7.2mG Glass Manual Thermostat

Stock No.
W85 x H85 x D46mm (31mm in wall)
Stock Status
In Stock
Stock No.
W85 x H85 x D46mm (31mm in wall)
Stock Status
In Stock

Technical Data

85x85x46mm (31mm in wall)
Protection Rating
Max Load
5215: Ice White 5216: Piano Black
Temperature Range
5 ~ 80°C (0.5°C increments)
Sensor rating
NTC 10kΩ @ 25°C

Frequently Asked Questions

What are the rough in or first fix requirements for Underfloor Heating and a Controller?

When roughing in for our Underfloor Heating and the controller, the electrician will first need to bring mains power to the Thermostat location. The electrician will then also need to run two 20mm conduits from the Thermostat position down to the floor, for the Underfloor Heating Cold Tail and for the Floor Sensor. For further information and a visual representation, please view our Conduit Requirements download.

Can I control my underfloor heating using C-Bus?

Yes, ensure that you purchase this Thermotouch 9.2mG Glass Manual Thermostat with your underfloor heating and this can be connected to and controlled by your C-Bus system.

What is a floor sensor?

A floor sensor is a small probe that is installed beneath the floor, between two runs of heating cable. This is connected to the Thermostat and gives an accurate reading of the floor temperature.

Will my Underfloor Heating Thermostat come with the Floor Sensor/probe?

Yes! All Underfloor Heating Thermostats supplied by Thermogroup come with a Floor Sensor and a 20mm flexible conduit to install the floor sensor in, making it easier to replace if necessary. You will find the Floor Sensor and Conduit in your Thermostat box, below the unit itself.

What temperature should I set my underfloor heating at?

Every situation is different however it is recommended to set your underfloor heating to 24°C to begin with. After testing for several days increase or decrease the temperature to find your comfort temperature. Please note a decrease of 1°C may not affect the comfort or warmth of the floor enough to make it noticeable but can help to reduce running costs.

Can I control multiple zones with one controller?

No, each zone that you want to have individual control over needs to have its own separate controller.

Planning Tools

Running Cost Calculator

Try our cost calculator to get an running cost estimate based on the size of your heating area and electricity tariff

Learn More

Quote Calculator

Use our simple to use quoting tool which will generate a quote for the supply of underfloor heating in a matter of minutes

Learn More